ACCESSORIES TO ADAPT FOR VARIOUS
DIAMETERS AND FIBER DRUMS

Model 55/30 Series, E14, and 725G-P
 

  • MORSE 55/30 Series adaptors, enable drum handlers to fit smaller drums

  • For use with only with the following  Models 185A-HD, 185A-BP, 285A, 285A-HD, 285A-BP and the 400 Series

 

 

 

 

 

  • 55/30-22
    Sized for drums close to 22" diameter

  • 55/30-20.5
    Sized for drums close to 20½" diameter

  • 55/30-19
    For standard steel 30 gallon drums and other drums close to 19" diameter (not shown)

  • 55/30-17.5
    Sized for drums close to 17½" diameter

  • 55/30-16
    Sized for drums close to 16" diameter (not shown)

  • Morse Drum-Adapters make it possible to handle several different diameter drums with the same Morse "Karrier"

  • Designed to be quickly added to Karrier's drum holder

  • Reduce grip diameter to match drums smaller than standard steel 55 gallon drums

  • Add the "Fibre Drum Strap" Model E14 for fibre drums or straight walled steel drums

Inside diameters listed in chart below intended to correspond to several of the most popular USA-made standard fibre drum sizes. Other sizes can be made on special order. Model 55/30 series are all steel. Also available with spark resistant parts: for example as model 55/30M-19.

Morse

Identify Drum Size 
by any of these measurements
Adaptor
Model No.1		 Inside
Diameter2		 Outside
Diameter3		 Circumference4
  55/30-22

21.5

22

67-1/2 to 69-1/8"
55/30-20.5

20

 20.5

62-7/8 to 64-3/8"

  55/30-19

18.5

 19 58-1/8 to 59-5/8"
55/30-17.5 17 17.5 53-1/2 to 54-7/8"

  55/30-16

15.5

16

48-7/8 to 50-1/4"

1NOTE: Also use E14 "'Fibre Drum Strap" for fibre drums and staight walled steel drums

2Fibre drums are often described by inside diameter.

3Calculated from measured circumference. (OD = CIRCUM / 3.14)

4Use a tape measure around the girth.

 

 

 

 

 

 

E14 FIBRE DRUM STRAP

  • Replaces cinch-chain of standard saddles to grip fibre and straight walled drums

  • Handle drums with diameters less than standard steel 55 gallon

  • Also available with spark resistant parts as E14SS which has stainless steel parts instead of ordinary carbon alloy steel

 

THREE-PIECE SADDLE - Part Number 725G-P

  • Provides alternate method for securing the drum into the saddle band

  • This is not an adaptor

  • It is a saddle assembly for 55 gallon steel drums, and is a permanent part of the drum handler

  • Model 185A, w/ chain & ratchet, can be field converted to Model 185G by replacing the saddle assembly with the three-piece saddle assembly, p/n 725G-P

 

Back

Request More InfoEnvelope.gif (4196 bytes)

Thank you.jpg (25178 bytes)